Installation and commissioning
Prior to installation, make a note of the serial number (12 digits underneath the barcode) in the battery compartment and the exact location of installation. You will need this later on for integrating the device in your SmartHome.
Installation as a free-standing device
Install the stand included in delivery on the rear of the room thermostat as a free-standing device. To do so, slide it from the rear into the grooves on the rear of the room thermostat as far as it will go. Then insert the two supplied batteries into the battery compartment.
Wall installation with wall bracket
Please use the accessories included in delivery for wall installation. Select an installation location at eye level to be able to read the display better and to set the temperature more precisely.
When choosing the installation location and drilling close to existing switches or sockets, pay close attention to the course of electrical lines and existing supply lines.
Proceed as follows for installation:
|1||Drill a hole with a diameter of 5 mm into the selected mounting location.|
|2||Insert one of the supplied dowels into the drilled hole.|
|3||Attach the wall bracket to the wall using the countersunk screw. Make sure that the grooves are arranged as shown in the drawing.|
|4||Make a note of the serial number located in the battery compartment of the room thermostat.|
|5||Insert the two supplied batteries into the battery compartment.|
|6||Now slide the room thermostat carefully downwards into the grooves of the wall bracket until it latches into place.|