Mounting on Danfoss radiator valves

For RAV valves, place the tappet extension C on the valve pin prior to installation. Snap on the appropriate adapter for the valve fully.

The RA and RAV adapters were produced to ensure a better fit with pre-loading.

During installation, use a screwdriver if necessary and bend open the adapters slightly in the area of the screw.

After snapping them onto the valve body, fasten the RA or RAV adapters with the enclosed screw and nut.

The RA and RAV adapters were produced to ensure a better fit with pre-loading.

During installation, use a screwdriver if necessary and bend open the adapters slightly in the area of the screw.

After snapping them onto the valve body, fasten the RA or RAV adapters with the enclosed screw and nut.

The RAVL adapter does not need to be screwed.

Ensure that the radiator thermostat is located within the reception range of the Smart Home central unit. If the reception at the relevant position is not sufficient, change the Smart Home central unit or use a second central unit to extend the range of the Smart Home network.